ft to m
Convert ft to m. Enter a value and view the calculation method, examples and conversion table.
Length converter
ft to m formula
The calculator converts the input to the category's reference unit, then divides by the target unit's factor.
Result = input × source factor ÷ target factor
1 × (0.3048 ÷ 1) = 0.3048
Worked example: 1 Feet = 0.3048 Meters
Auto mode preserves significant digits for small values; manual mode rounds to the selected decimal places. ≈ means approximate; < means below the display limit. Extreme values use × 10ⁿ. Calculations are rounded only for display.
ft to m conversion table
| Feet | Meters |
|---|---|
| 1 Feet | 0.3048 Meters |
| 2 Feet | 0.6096 Meters |
| 5 Feet | 1.524 Meters |
| 10 Feet | 3.048 Meters |
| 20 Feet | 6.096 Meters |
| 50 Feet | 15.24 Meters |
| 100 Feet | 30.48 Meters |
| 250 Feet | 76.2 Meters |
| 500 Feet | 152.4 Meters |
| 1,000 Feet | 304.8 Meters |
Definitions and assumptions
Length factors are expressed relative to metres. The international foot is exactly 0.3048 m and the inch is exactly 0.0254 m. These definitions do not represent the former US survey foot.
How to use this calculator
- Enter the value you want to convert.
- Choose the source and target units, then adjust the display precision if needed.
- Read the result. Select Convert to open a page for this value, or use the table below.
Frequently asked questions
how many m is 1 ft?
1 Feet = 0.3048 Meters. Auto mode preserves significant digits for small values; manual mode rounds to the selected decimal places. ≈ means approximate; < means below the display limit. Extreme values use × 10ⁿ. Calculations are rounded only for display.
how to convert ft to m?
The calculator converts the input to the category's reference unit, then divides by the target unit's factor. 1 × 0.3048 ≈ 0.3048 Meters. Use the source and target factors shown in the formula. The worked example uses the value on this page, and the table provides other common values.
Can the result be shown as feet and inches?
This calculator shows decimal feet or decimal inches. For a mixed format, take the whole feet and multiply the remaining fraction by 12 to obtain inches.
Why is the displayed result rounded?
Auto mode preserves significant digits for small values; manual mode rounds to the selected decimal places. ≈ means approximate; < means below the display limit. Extreme values use × 10ⁿ. Calculations are rounded only for display.
What input range can I use?
This calculator accepts non-negative values up to 1 trillion, with up to 8 decimal places. It does not calculate signed vectors or calendar date intervals.
Why is a unit unavailable?
A conversion is unavailable when a verified unit definition or a current exchange-rate value has not been configured. The tool does not invent a coefficient.
Sources and methodology
Methods and sources · Content revised
Report a problem